Skip to main content

Featured

Space Explorers Book 12: Next Adventure

Memunic Space Explorers › Book 12: Memoon and the Biggest Question › Next Adventure Next Adventure This is the last book in the Memunic Space Explorers series, so the next adventure is yours. Book 1 began with a small slip of paper in the Question Jar: Where did everything come from? You now know much more about how people go about answering it. You know what light can tell us, how a stretching space leaves its mark, and how careful honesty about what we do not know is part of the science. Turn back to Book 1 and read it again. Notice how much more you see in it now. Then take out a fresh slip of paper and write your own question. Memoon will keep the jar open for you. ← Sources and Fact-check · Book 12 contents Keep exploring with Memunic Space Explorers Continue with Book 12: Memoon and the Biggest Question , or see all twelve books in the series . Find more Memunic ebooks on MemuniCity .

Space Explorers Book 9: Chapter 6 – How Gravity Fades

Memunic Space Explorers › Book 9: Memoon and the Clockwork Sky › Chapter 6: How Gravity Fades

Chapter 6: How Gravity Fades

In this chapter: use the inverse-square idea to compare gravity at different distances and on different worlds, and test a dramatic claim with numbers.

“Gravity,” said Beautine, “stops.”

She had climbed onto the water tank for the announcement, which gave it extra weight. The others, scattered across the terrace with notebooks and snacks, looked up.

“At the edge of space, gravity ends. That is why the astronauts float. Down here, gravity holds you. Up there, there is none. A hundred kilometres up, perhaps, it ends. I read it online.”

“Where online?” said Kachui.

“A very confident website.”

Memoon put down her pencil. “A hundred kilometres is a number people use as the edge of space. It is a useful line to draw for reasons of law and flight. But it does not tell us where gravity ends. Gravity does not have a border. We can test whether it has one.”

“How?” said Noodles.

“Look at the Moon,” said Memoon.

The Moon was rising low over the rooftops, pale gold and a little lopsided. “If gravity stopped at a hundred kilometres, the Moon, which is almost four hundred thousand kilometres away, would not feel Earth’s pull at all. It would go off in a straight line.”

“It is not going off in a straight line,” said Simbha.

“No. It keeps circling Earth, once in about a month. Something is bending its path. So gravity reaches at least that far. It gets weaker with distance, and it never reaches zero.”

Beautine climbed down from the tank, slowly. “Then how weak? A drop from full to nearly nothing?”

“We need a rule,” said Kachui, “and I do not yet have one. Let us look for a pattern.”

Nimo, who liked patterns, rose in his bubble. “May I begin with a torch?”

Memoon fetched the red torch from her bag. “What is the comparison?” she asked.

“Shine the torch on a wall from one metre away. You get a circle of light. Now stand two metres away. The circle gets wider. How much wider?”

Memoon measured with a ruler. At one metre, the circle was eight centimetres across. At two metres, it was sixteen. “Twice the width.”

“Twice the width,” said Nimo, “but the area of a circle goes with the width squared. So double the width is four times the area. The same light is spread over four times the space, so each patch of wall gets only a quarter as much light.”

“That is called an inverse-square law,” said Kachui. “Double the distance and the brightness drops to one quarter. Triple it, and one ninth.”

“It works for gravity too,” said Memoon, “but I want to check, not just assume. This is an analogy, and I have not yet shown that gravity follows the rule. I only know that the torch does. The limit is that gravity is not a beam of light spreading out. Nobody should say it is.”

Kachui tapped his phone. “Newton thought the pull of gravity falls off with the square of the distance from the centre of a body. We can try it on the data we know. On Earth’s surface, we are about 6,371 kilometres from the centre. At that distance, g is 9.81 newtons per kilogram. If we go to twice that distance from the centre, 12,742 kilometres, what do we expect?”

“A quarter,” said Noodles. “Two point four five.”

“Good,” said Kachui. “And at three times the distance?”

“One ninth,” said Beautine, suddenly engaged. “About one point one.”

Kachui wrote a table in the notebook:

Distance from Earth’s centre (in Earth radii) 1, 2, 3, 6, 10. Predicted g in N/kg: 9.81, 2.45, 1.09, 0.27, 0.098.

“Now the station,” said Memoon. “It circles Earth about 400 kilometres above the surface. That is not 400 kilometres from the centre. It is 6,371 plus about 413, so about 6,784 kilometres from the centre. What fraction of the surface distance is that?”

Beautine did the division with her tongue between her teeth. “One point oh six five. A very small increase.”

“So by the inverse-square rule,” said Kachui, “g up there should be 9.81 divided by 1.065 squared. That is 1.134. So 8.65.”

“Eight point six five,” said Memoon. “That is about 88 per cent of what it is down here.”

The terrace went quiet. Noodles scratched his ear.

“So at the station,” said Beautine, a little quietly, “gravity is still 88 per cent as strong as on my terrace.”

“Yes.”

“Then an astronaut who weighs 600 newtons here has gravity pulling on them with 530 newtons up there.”

“That is right,” said Kachui. “The astronaut has not lost any pull. What they have lost is the feeling of the floor pushing back, because they and the station are falling together. The pull is nearly as strong. The weightlessness is something else.”

Beautine sat down on a stool. “I would like to withdraw my statement about gravity stopping at a hundred kilometres.”

“Noted,” said Kachui, who wrote: Beautine’s claim: gravity ends at 100 km. Evidence: the Moon is still held at 384,000 km; the station is held at 88%. Claim rejected.

“That is harsh,” said Beautine.

“It is only harsh if you are attached to the claim,” said Memoon. “If you are attached to the test, it was a very good claim.”

Noodles, meanwhile, had gone quiet and was drawing in the margin of the notebook. “There is something else I want to know. If gravity depends on distance, why is it so different on other worlds? On Jupiter it is two and a half times what it is here. But Jupiter is way bigger. Shouldn’t I be further from the centre, and feel less?”

“You have found the right puzzle,” said Kachui. “There are two things at work. The first is the mass of the world: more mass, stronger pull. The second is how far you stand from its centre. On Jupiter’s cloud tops you are about eleven Earth radii from the centre. That divides the pull by about a hundred and twenty-five. But Jupiter has about three hundred and eighteen times Earth’s mass. Three hundred and eighteen divided by a hundred and twenty-five is about 2.5.”

“So g on Jupiter’s cloud tops is 2.5 times Earth’s,” said Memoon. “2.5 times 9.81 is about 24.5. The measured value is 24.79. Close, and it shows the idea fits.”

“And the Moon?” said Beautine. “The same trick?”

Kachui checked. “The Moon has about one-eighty-first of Earth’s mass, and its radius is about 0.27 of Earth’s. The radius squared is about 0.074. So one divided by 81, which is 0.0123, divided by 0.074, gives about 0.165. And 0.165 times 9.81 is about 1.62. That matches the measured 1.62.”

“That is quite satisfying,” said Beautine.

“It should be,” said Nimo. “You have done what astronomers do: used a rule from one place to predict a value in another, then compared it with a measurement.”

They wrote the rule at the top of a clean page:

Analogy: a torch on a wall g against distance from Earth's centre

1m 2m 3m 9.81

1 square station: 8.65

4 squares g (N/kg)

9 squares 2.45

1.09

Same light, spread over 1, 4, 9 squares:0
each square gets 1, ¼, ⅑ as much.123456

Distance from the centre (Earth radii) Gravity is not a beam; this only shows why a quantity that spreads out follows 1/distance². Station: 413 km up = 1.065 Earth radii from the centre; g is 88% of 9.81.

The torch is an analogy for spreading out; gravity is not a beam.

g depends on the mass of the world, and on one over the distance from its centre, squared.

Memoon looked at the Moon again. It had risen higher now, small and calm over the rooftops. “I have a question,” she said. “If the Moon feels Earth’s pull, why does it not fall into Earth?”

There was a pause.

“Maybe,” said Simbha, “it is falling, but it keeps missing.”

Science Corner Gravity weakens with distance but never reaches zero. The inverse-square law says that if the distance from a body’s centre doubles, the pull falls to one quarter; if it triples, to one ninth. The gravitational field strength g near a world depends on its mass and on the square of the distance from its centre. On Earth’s surface g is about 9.81 N/kg. At the space station’s height (about 413 km above the surface, roughly 6,784 km from Earth’s centre), g is about 8.65 N/kg, about 88% of its surface value. Astronauts feel weightless because they are in free fall, not because gravity has vanished. Surface g differs between worlds because mass and radius both differ: Moon 1.62, Mars 3.71, Jupiter cloud tops 24.79 N/kg. Story note: the torch beam shows why a quantity that spreads out falls as the inverse square of distance, but gravity is not a beam and nothing is “spreading”; this is only an analogy. The 100 km edge of space is a convention used for flight and law; gravity has no edge. The space station’s height varies by a few kilometres over time. Where this idea stops working: the inverse-square rule treats each world as a point at its centre and works for round bodies; real worlds are slightly lumpy.

Space Detective 1. Beautine says that gravity ends at 100 km. Use the Moon and the space station as evidence against her claim. 2. At three times Earth’s radius from the centre, what is g? Show the calculation and say what happens to an astronaut’s pull compared with the surface. 3. Draw a graph of g against distance (in Earth radii) for 1, 2, 3 and 6, and describe the curve.

Try it: The Torch and the Wall Time: 20 minutes.

Adult: An adult should be present and nobody should shine the torch at faces. You need: a torch, a wall in a dim room, a ruler, a helper.

Do: Shine the torch on the wall from 1 m, 2 m and 3 m. Measure the width of the lit circle each time. Compare the area (width squared) with the distance. What to expect: the circle’s width roughly doubles and triples, and so the lit area grows about 4 and 9 times. Real torches have uneven beams, so expect rough numbers.

Cloudy or low-resource day: use paper circles cut to the widths 1, 2 and 3 and count how many unit squares cover each.

Limitation: this shows the maths of spreading, but not gravity itself.

Next time: The Moon is falling, and missing. How can anything fall and never land?

← Chapter 5: Every Push Has a Partner · Book 9 contents · Chapter 7: Falling Sideways →

Keep exploring with Memunic Space Explorers

Continue with Book 9: Memoon and the Clockwork Sky, or see all twelve books in the series. Find more Memunic ebooks on MemuniCity.

Comments

Popular posts from this blog

CA-7 Job Status and Failure Reason Codes

Here are the various status codes that You may see for jobs in the Queue or Logs in CA-7. R-C0002 R-C0003 R-C0099 R-C0255 R-JCLER A-U0002 A-U0004 A-U0015 A-U0043 A-U4095 A-SOC7 A-U4000 Reason Code/Job Status Code explanation: The indication of the job's current disposition. Values and their meanings are: A-Snnnn-- The job has failed with a system abend. A-Unnnn --The job has failed with a user abend. C-Cnnnn --The job has completed successfully and is going through completion processing. E-ARFATT-- An error occurred during the attempt to attach ARF definitions. This can result if the ARFSET specified is not defined. A diagnostic message may have been written to the CA-7 log, the OS console, or to the trailer queue for the job (in which case it can be displayed using LQ,JOB=x,LIST=ALL). E-ARFERR ---The job encountered an error in the ARF processing. Do a LARFQ command for the job to get more specific information. E-SEGERR --The job has been requeued...

Whistling Winds and Waterfalls: 4 Days of Magic in Shillong

Nestled in the clouds, where the scent of pine trees mingles with the rhythm of waterfalls and the tunes of local guitar-strumming youth—Shillong is more than a place. It’s a vibe. If you’ve got 3 nights and 4 days, you’ve got just enough time to fall in love. Here’s how to make the most of it—food, fun, fog and fantastic views included. Day 1: Shillong, We’re Coming for You! You land in Guwahati, barely out of the airport when the hills start calling. You hop into your cab, Spotify on, windows down, and the three-hour ride to Shillong begins. Just when you think it can’t get better, you stop at Umiam Lake —a lake so calm, it looks like someone ironed the water. By evening, you’re sipping hot chai in Laitumkhrah, maybe nibbling on spicy momos or pork jadoh from a roadside stall. You’re checked into your charming hotel ( Tripura Castle if you fancy old-world royalty, Ri Kynjai if you’re into lakeside poetry). The breeze whispers secrets of waterfalls and pine forests. Sleep well, drea...

Installing and Configuring Hadoop on Ubuntu as a Pseudo Distributed Single Node Cluster

Briefly what is psuedo-distributed single node Hadoop cluster: It is a Hadoop distributed cluster having Single Node. All the five daemons (NN,DN,JT,TT,SNN) are running as individual JVM (java process) instances. We will get all distributed features of Hadoop. This mode is used to develop, test, and staging (before production) Map Reduce programs quickly. It writes all the system, daemon and user logs to different files on the cluster To install Hadoop in this mode, we have to modify the hadoop-env.sh, core-site.xml, hdfs-site.xml, mapred-site.xml. hadoop-env.sh contains all the Environment variables which are required for running Hadoop. All the default values are fine, Only we have to modify the JAVA_HOME=“The location of Java Home Directory” Core-site.xml contains all the cluster specific information like io, temp directory, sorting, file system uri etc. Hdfs-site.xml contains all the parameters which are specific to HDFS like name node directory, data node directory...