Skip to main content

Featured

Space Explorers Book 6: Look Up Tonight

Memunic Space Explorers › Book 6: Memoon and the Light from Long Ago › Look Up Tonight Look Up Tonight November to April evenings: Aldebaran (Rohini) shines orange in the east after dark in November and climbs higher through the winter. Look for the V-shaped cluster beside it and the little cluster of the Pleiades ahead of it. By late April it is low in the west after sunset. Winter evenings: Orion the hunter rises in the east, close to Aldebaran. His bright stars are at very different distances, a good test of the bead idea. Every year in mid-December: the Geminid meteor shower, one of the best of the year. Watch after midnight from a dark place, with an adult. Any dark, moonless night: the Milky Way can be seen from places far from city lights. 28 February every year, National Science Day: the GMRT near Pune opens to visitors on 28 February and the following day, without registration. On other days, groups can book Friday visits. ← Mistake Museum · Book 6 contents · Sky Clu...

Space Explorers Book 3: Chapter 7 – How Far?

Memunic Space Explorers › Book 3: Memoon’s Model Solar System › Chapter 7: How Far?

Chapter 7: How Far?

Illustration for Space Explorers Book 3: Chapter 7 – How Far?

On Tuesday, Kachui carried a long roll of paper out to the garden path. It was the backs of Beautine’s old calendars, taped end to end.

“This is my model of distances,” he said. “Ten centimetres on this strip stands for the distance from the Sun to Earth. That is about 150 million kilometres in real life.”

He put the Sun at one end and made small pencil ticks. “Mercury at 4. Venus at 7. Earth at 10. Mars at 15.” He crawled along the strip. “Jupiter at 52. Saturn at 96. Uranus at 192. Neptune at 302.”

“That is three metres and two centimetres,” said Beautine, who had counted with her tail.

Kachui’s paper strip: the first planets are close to the Sun, and then the gaps grow.

Noodles walked slowly along the strip. “The first four planets are squashed together at one end,” he said. “And then there are huge gaps.”

“The inner planets are close together, and the outer planets are far apart,” said Kachui. “And look at this. On this strip, how wide is the Sun?”

“A hand?” guessed Noodles.

“About one millimetre. A pinhead. And Earth is far too small to see.”

Distance from the Sun on the paper strip 10 cm on the strip stands for the Sun-to-Earth distance

4 cm7 cm10 cm15 cm
MercuryVenusEarthMars

0 cm 50 cm 100 cm 150 cm 200 cm 250 cm 300 cm

52 cm96 cm192 cm302 cm
JupiterSaturnUranusNeptune

The four inner planets are squeezed into the first 15 cm.

Distances only, drawn to one scale (10 cm is about 150 million km, rounded). Planet sizes are NOT to scale, and the planets are not really in a line.

Noodles tried to set the bead down on the strip, right on the 10 cm tick. “The bead we used for Earth is more than a thousand times too big.”

“Then let us do the opposite,” said Memoon. “Keep the beads and the fruit, and put the planets where they belong on that scale. Simbha, you are our measuring lion. Your stride is about one metre.”

Simbha placed the chalk Sun at one end of the lane. He took the bead and began to walk, counting in a deep rumble. “...one hundred and fifteen. One hundred and sixteen. One hundred and seventeen.” Far away, he put the bead down.

Noodles squinted. The Sun back at the start was just a white circle, and the bead was almost invisible. “That tiny dot is Earth?”

“One hundred and seventeen metres from the Sun,” said Kachui. “And the Moon would be a seed about 30 centimetres from the bead, as far as a ruler. Neptune would be about three and a half kilometres away, about three-quarters of an hour of walking.”

Simbha places the bead 117 strides away. The chalk Sun is a tiny circle far behind him.

“I do not walk,” said Noodles. “I am carried.”

Nimo’s bubble wobbled. “There is so much room. Something must fill it up, the way water fills my pond, to hold the planets in place.”

“That is a very fishy idea,” said Memoon kindly. “But the space between the planets is almost empty. Water holds a fish up. Space does not hold a planet up. We will find out what keeps the planets going round in a later adventure.”

“Imagine Mode on,” said Nimo, and his bubble shot down the lane, quick as an imaginary thought, past Simbha, past the bead, all the way to the end. “Imagine Mode off,” he called, and rolled back to the others.

“That is not how real spacecraft travel,” said Memoon. “They are much slower, and they take years to reach the outer planets.”

Memoon sat down in the middle of the lane with her notebook. “Now I know why our model kept going wrong,” she said. “On one table we can show how big the planets are, or how far apart they are. But not both on the same scale. If the Sun were on the table, Neptune would be about three and a half kilometres away. And if everything fitted on the table, the planets would be too small to see.”

“So what do we do for Fair Day?” asked Beautine.

“We make more than one model,” said Memoon. “And each one says what it shows well and what it gets wrong.”

She wrote: Fix number five. Space is mostly empty. One table cannot show real sizes and real distances at the same scale.

“One question is left,” said Kachui, looking up at the evening sky. “Dot.”

Look closer The distances between planets are huge compared with the sizes of planets. The Solar System is mostly empty space. On a paper strip where Earth is 10 cm from the Sun, the planets are at Mercury 4 cm, Venus 7 cm, Earth 10 cm, Mars 15 cm, Jupiter 52 cm, Saturn 96 cm, Uranus 192 cm and Neptune 302 cm. On that strip the Sun is about 1 mm wide, and Earth is far too small to see. If Earth is a 1 cm bead and the Sun is a circle 109 cm wide, Earth is about 117 m from the Sun and Neptune is about 3.5 km away. The Moon is a tiny seed about 30 cm from the Earth bead. One table cannot show real sizes and real distances at the same scale. A good model says which one it shows. Story note: Imagine Mode is the story’s way of pretend travel. Real spacecraft are much slower and take years to reach the outer planets. Nimo’s idea that space is full of water is a mistake: the space between the planets is mostly empty, and what keeps the planets going round comes in a later book. On the strip, 10 cm stands for about 150 million km, the distances are rounded, and the planets are not really in a straight line. Simbha’s stride is taken as 1 m. Talking animals are part of the story; the science is real.

Space Detective questions 1. On Kachui’s strip, how far from the Sun is Jupiter? How much farther from the Sun is Jupiter than Earth? 2. Why could the friends not show real sizes and real distances at the same scale on one table? 3. Draw a short strip with the Sun at one end. Mark where Earth (10 cm), Mars (15 cm) and Jupiter (52 cm) would go, using any scale you like.

Try it: The Solar System Strip Time: 30 minutes. Adult: An adult helps with measuring and any cutting. You need: a strip of paper about 3 m 10 cm long (taped sheets or an old roll), a ruler or tape measure, a pencil and sticky notes. Do: Put the Sun at one end. Mark each planet at 4, 7, 10, 15, 52, 96, 192 and 302 cm from the Sun, and write each planet’s name on a sticky note. Then walk along the strip and say the planets in order. Expect: the first four planets are crowded into the first 15 cm, and then the gaps grow wide. Indoors or low-resource: no paper? Tie knots in a rope or a washing line at the same distances. You can feel the gaps with your hands. Limits: the planets are not really in a straight line, and the planets themselves are far too small to show at this scale.

Next time: One question is still unanswered. What is the bright dot that does not twinkle?

← Chapter 6: How Big? · Book 3 contents · Chapter 8: Planet or Star? →

Keep exploring with Memunic Space Explorers

Continue with Book 3: Memoon’s Model Solar System, or see all twelve books in the series. Find more Memunic ebooks on MemuniCity.

Comments

Popular posts from this blog

CA-7 Job Status and Failure Reason Codes

Here are the various status codes that You may see for jobs in the Queue or Logs in CA-7. R-C0002 R-C0003 R-C0099 R-C0255 R-JCLER A-U0002 A-U0004 A-U0015 A-U0043 A-U4095 A-SOC7 A-U4000 Reason Code/Job Status Code explanation: The indication of the job's current disposition. Values and their meanings are: A-Snnnn-- The job has failed with a system abend. A-Unnnn --The job has failed with a user abend. C-Cnnnn --The job has completed successfully and is going through completion processing. E-ARFATT-- An error occurred during the attempt to attach ARF definitions. This can result if the ARFSET specified is not defined. A diagnostic message may have been written to the CA-7 log, the OS console, or to the trailer queue for the job (in which case it can be displayed using LQ,JOB=x,LIST=ALL). E-ARFERR ---The job encountered an error in the ARF processing. Do a LARFQ command for the job to get more specific information. E-SEGERR --The job has been requeued...

Whistling Winds and Waterfalls: 4 Days of Magic in Shillong

Nestled in the clouds, where the scent of pine trees mingles with the rhythm of waterfalls and the tunes of local guitar-strumming youth—Shillong is more than a place. It’s a vibe. If you’ve got 3 nights and 4 days, you’ve got just enough time to fall in love. Here’s how to make the most of it—food, fun, fog and fantastic views included. Day 1: Shillong, We’re Coming for You! You land in Guwahati, barely out of the airport when the hills start calling. You hop into your cab, Spotify on, windows down, and the three-hour ride to Shillong begins. Just when you think it can’t get better, you stop at Umiam Lake —a lake so calm, it looks like someone ironed the water. By evening, you’re sipping hot chai in Laitumkhrah, maybe nibbling on spicy momos or pork jadoh from a roadside stall. You’re checked into your charming hotel ( Tripura Castle if you fancy old-world royalty, Ri Kynjai if you’re into lakeside poetry). The breeze whispers secrets of waterfalls and pine forests. Sleep well, drea...

Installing and Configuring Hadoop on Ubuntu as a Pseudo Distributed Single Node Cluster

Briefly what is psuedo-distributed single node Hadoop cluster: It is a Hadoop distributed cluster having Single Node. All the five daemons (NN,DN,JT,TT,SNN) are running as individual JVM (java process) instances. We will get all distributed features of Hadoop. This mode is used to develop, test, and staging (before production) Map Reduce programs quickly. It writes all the system, daemon and user logs to different files on the cluster To install Hadoop in this mode, we have to modify the hadoop-env.sh, core-site.xml, hdfs-site.xml, mapred-site.xml. hadoop-env.sh contains all the Environment variables which are required for running Hadoop. All the default values are fine, Only we have to modify the JAVA_HOME=“The location of Java Home Directory” Core-site.xml contains all the cluster specific information like io, temp directory, sorting, file system uri etc. Hdfs-site.xml contains all the parameters which are specific to HDFS like name node directory, data node directory...